+8618657514717

Method For Distinguishing The Advantages And Disadvantages Of Mining Cables

Feb 06, 2021

One, the cover: indoor cable is generally made of polyvinyl or flame retardant polyvinyl ethylene, the appearance should be smooth, bright, flexible, easy to peel.

Bad quality cable skin finish is not good, easy and inside the tight set, aramid adhesion.

The PE sheath of outdoor optical cable should be made of high quality black polyethylene. After the cable is made, the outer skin is smooth, bright, uniform in thickness and no small bubbles.

The outer skin of inferior optical cable is generally produced with recycled materials, which can save a lot of costs. Such optical cable skin is not smooth, because there are a lot of impurities in the raw material, and the outer skin of the optical cable has a lot of tiny pits. For a long time, it will crack and water.

Fiber: regular cable production enterprise generally USES metal grade A fiber core, some cheap inferior cable typically use C, D fiber and unknown smuggling fiber, the fiber source is complicated, the factory for A long time, often feel has damp discoloration, and multimode optical fiber is often mixed with single mode fiber, and the lack of necessary testing equipment of general small plant, not to judge the quality of optical fiber.

Because the naked eye can not identify such fiber, the construction of the problem is often encountered: the bandwidth is very narrow, short transmission distance;

The thickness is not uniform and can not be butted with the tail fiber;

Optical fibers lack flexibility and break when they bend.

Three, strengthen the steel wire: regular manufacturers of outdoor cable steel wire is after phosphating treatment, the surface is gray, such a steel wire into the cable does not increase hydrogen loss, does not rust, high strength.

Poor quality cable is usually replaced by thin wire or aluminum wire, the identification method is very easy - white appearance, pinch in the hand can bend at will.

With such steel wire production of optical cable hydrogen loss, a long time, hanging the two ends of the optical fiber box will rust fracture.

Four, steel armor: regular production enterprises use double-sided brush antirust coating longitudinal binding grain steel belt, inferior optical cable is used in ordinary iron, usually only one side has been treated with antirust.

Five, loose sleeve: fiber optic cable should be installed in the loose sleeve PBT material, such sleeve high strength, no deformation, anti-aging.

Inferior cable is generally made of PVC sleeve, such sleeve diameter is very thin, with a pinch on the flat hand, a bit like we drink the straw.

Six, fiber paste: fiber paste in the outdoor cable can prevent fiber oxidation, because of moisture into the moisture, fiber paste used in inferior fiber is very few, seriously affecting the life of fiber.

Seven, aramid fiber: also known as Kevlar, is a kind of high strength chemical fiber, currently used in the military industry most, military helmet, bulletproof vest is this material production.

At present, only DuPont and Aksu in the Netherlands can produce it, and the price is about 300000 tons.

Indoor optical cable KYDL_SYEY and power overhead optical cable (ADSS) are reinforced with aramid yarn. Because of the high cost of aramid fiber, the outer diameter of inferior indoor optical cable is generally made very thin, so that a few strands of aramid fiber can be used less to save costs.

Such cables can easily be pulled apart when pierced.

ADSS cable because it is based on the span, wind speed per second to determine the use of aramide fiber cable, generally dare not cut corners.



Send Inquiry